Pennsylvania Code & Bulletin
COMMONWEALTH OF PENNSYLVANIA

• No statutes or acts will be found at this website.

The Pennsylvania Code website reflects the Pennsylvania Code changes effective through 53 Pa.B. 8238 (December 30, 2023).

25 Pa. Code § 130.603. Standards.

§ 130.603. Standards.

 (a)  VOC content limits. Except as provided in subsections (b), (c) and (g), a person after January 1, 2005, may not:

   (1)  Manufacture, blend or repackage for sale within this Commonwealth a coating subject to this subchapter with a VOC content in excess of the corresponding limit specified in Table 1.

   (2)  Supply, sell or offer for sale within this Commonwealth a coating subject to this subchapter with a VOC content in excess of the corresponding limit specified in Table 1.

   (3)  Solicit for application or apply within this Commonwealth, a coating subject to this subchapter with a VOC content in excess of the corresponding limit specified in Table 1.

 (b)  Most restrictive VOC limit. If on the container of an architectural or industrial maintenance coating, or a label or sticker affixed to the container, or in sales, advertising or technical literature supplied by a manufacturer or a person acting on their behalf, a representation is made that indicates that the coating meets the definition of or is recommended for use for more than one of the coating categories listed in Table 1, then the most restrictive VOC content limit applies. This provision does not apply to the following coating categories:

   (1)  Lacquer coatings (including lacquer sanding sealers).

   (2)  Metallic pigmented coatings.

   (3)  Shellacs.

   (4)  Fire-retardant coatings.

   (5)  Pretreatment wash primers.

   (6)  Industrial maintenance coatings.

   (7)  Low-solids coatings.

   (8)  Wood preservatives.

   (9)  High-temperature coatings.

   (10)  Temperature-indicator safety coatings.

   (11)  Antenna coatings.

   (12)  Antifouling coatings.

   (13)  Flow coatings.

   (14)  Bituminous roof primers.

   (15)  Specialty primers, sealers and undercoaters.

   (16)  Calcimine recoaters.

   (17)  Impacted immersion coatings.

   (18)  Nuclear coatings.

   (19)  Thermoplastic rubber coatings and mastic.

 (c)  Sell-through of architectural or industrial maintenance coatings. An architectural or industrial maintenance coating manufactured prior to January 1, 2005, may be sold, supplied, offered for sale or applied after January 1, 2005, so long as the architectural or industrial maintenance coating complied with the standards in effect at the time the coating was manufactured.

 (d)  Thinning. A person may not apply or solicit the application of an architectural and industrial maintenance coating that is thinned to exceed the applicable VOC limit specified in Table 1.

 (e)  Rust-preventive coatings. A person may not apply or solicit the application of a rust-preventive coating for industrial use, unless the rust-preventive coating complies with the industrial maintenance coating VOC limit specified in Table 1.

 (f)  Coatings not listed in Table 1. For an architectural or industrial maintenance coating that does not meet the definitions for the specialty coatings categories listed in Table 1, the VOC content limit shall be determined by classifying the coating as a flat coating or a nonflat coating, based on its gloss as defined in §  130.602 (relating to definitions), and the corresponding flat or nonflat coating limit applies.

 (g)  Lacquers. Notwithstanding the provisions of subsection (a), a person or facility may add up to 10% by volume of VOC to a lacquer to avoid blushing of the finish during days with relative humidity greater than 70% and temperature below 65°F, at the time of application, provided that the coating contains acetone and no more than 550 grams of VOC per liter of coating, less water and exempt compounds, prior to the addition of VOC.

Table 1


VOC Content Limits for Architectural and Industrial Maintenance Coatings

 The VOC content limits are effective on January 1, 2005, and are expressed in grams of VOC per liter1 of coating thinned to the manufacturer’s maximum recommendation, excluding the volume of any water, exempt compounds, or colorant added to tint bases. ‘‘Manufacturer’s maximum recommendation’’ means the maximum recommendation for thinning that is indicated on the label or lid of the coating container.

Coating CategoryVOC Content Limit
Nonspecialty Coatings
Flat Coatings 100
Nonflat Coatings 150
Nonflat High Gloss Coatings 250
Specialty Coatings
Antenna Coatings 530
Antifouling Coatings 400
Bituminous Roof Coatings 300
Bituminous Roof Primers 350
Bond Breakers 350
Calcimine Recoaters 475
Clear Wood Coatings
—Clear Brushing Lacquers 680
—Conversion Varnish 725
—Sanding Sealers (other than Lacquer Sanding Sealers) 350
—Varnishes350

   



   1 Conversion factor: 1 pound VOC per gallon (U.S.) = 119.95 grams per liter.


Coating CategoryVOC Content Limit
Concrete Curing Compounds 350
Concrete Surface Retarders 780
Dry Fog Coatings 400
Faux Finishing Coatings 350
Fire-Resistive Coatings 350
Fire-Retardant Coatings
—Clear 650
—Opaque 350
Floor Coatings 250
Flow Coatings 420
Form-Release Compounds 250
Graphic Arts Coatings (Sign Paints) 500
High-Temperature Coatings 420
Impacted Immersion Coatings 780
Industrial Maintenance Coatings 340
Lacquers (including Lacquer Sanding Sealers) 550
Low-Solids Coatings 1202
Magnesite Cement Coatings 450
Mastic Texture Coatings 300
Metallic Pigmented Coatings 500
Multi-Color Coatings 250
Nuclear Coatings 450
Pretreatment Wash Primers 420
Primers, Sealers, and Undercoaters 200
Quick-Dry Enamels 250
Quick-Dry Primers, Sealers and Undercoaters 200
Recycled Coatings 250
Roof Coatings 250
Rust-Preventive Coatings 400
Shellacs
—Clear 730
—Opaque 550
Specialty Primers, Sealers and Undercoaters 350
Stains 250

   



   2 Including water and exempt solvents

Coating CategoryVOC Content Limit
Swimming Pool Coatings 340
Swimming Pool Repair and Maintenance Coatings 340
Temperature-Indicator Safety Coatings 550
Thermoplastic Rubber Coatings and Mastic 550
Traffic Marking Coatings 150
Waterproofing Sealers 250
Waterproofing Concrete/Masonry Sealers 400
Wood Preservatives 350

Cross References

   This section cited in 25 Pa. Code §  130.606 (relating to application for variance); 25 Pa. Code §  130.607 (relating to variance orders); 25 Pa. Code §  130.609 (relating to extension, modification or revocation of variance); and 25 Pa. Code §  130.611 (relating to compliance provisions and test methods).



No part of the information on this site may be reproduced for profit or sold for profit.


This material has been drawn directly from the official Pennsylvania Code full text database. Due to the limitations of HTML or differences in display capabilities of different browsers, this version may differ slightly from the official printed version.